Journal of Mining and Metallurgy, Section B: Metallurgy - vol. 53 (2) B - 2017

M. Vončina, M. Petrič, P. Mrvar, J. Medved

Thermodynamic characterization of solidification and defects that occur in Mg-alloy AM60

J. Min. Metall. Sect. B-Metall. 53 (2) B (2017) 107-114. DOI:10.2298/JMMB160609009V
Full text (pdf),
Export manuscript information:
RIS Format (EndNote, Reference Manager), BibTeX

Abstract

The AM60 alloy was thermodynamically examined using chemical analysis, thermodynamic calculation made by ThermoCalc program, “in situ” thermal analysis and differential scanning calorimetry (DSC), whereas the microstructure constituents were confirmed using optical and scanning electron microscopy (SEM). At the eutectic temperature of 437 °C the equilibrium solubility of Al in Mg is 12.6 wt. % Al. On the boundaries of the primary Mg grains the intermetallic compound of Al12Mg17 is precipitating according to the solvus line of the Mg-Al phase diagram. Solidification of the AM60 alloy has been investigated using “in situ” simple thermal analysis. The investigation of solidification has been taking place by evaluation of the cooling curves in connection with metallographic examinations, differential scanning calorimetry and thermodynamic calculations. All defects, nonmetallic inclusions and intermetallic compounds that occur in investigated AM60 alloy were identified.
Keywords: AM60 Mg-alloy; Thermodynamic calculation; Inclusions; Differential scanning calorimetry (DSC)
Correspondence Address:
M. Vončina, University of Ljubljana, Faculty of Natural Science and Engineering,
Department of Materials and Metallurgy, Ljubljana, Slovenia
This email address is being protected from spambots. You need JavaScript enabled to view it.

Creative Commons License
This work is licensed under a
Creative Commons Attribution-
ShareAlike 4.0 International License